Adjust the door on your Samsung dishwasher

How to Adjust the Door on Your Samsung Dishwasher

Learn how to properly adjust the door tension on your Samsung dishwasher to prevent it from falling open when using custom panels. Includes safety tips, screw adjustment steps, and weight guidelines.

If your Samsung dishwasher door doesn't stay in place when opened—especially after installing a custom panel—you can resolve this by adjusting the tension screws. This issue commonly occurs with FBI (fully built-in) and SBI (semi built-in) models when the custom panel exceeds the recommended weight or dimensions.

1. Why Does My Samsung Dishwasher Door Not Stay Open?

- The custom door panel exceeds the maximum weight limit specified in your user manual.

- The custom panel does not match the required dimensions for your dishwasher model.

- The tension screws on the dishwasher have not been properly adjusted for the added weight of the panel.

2. Supported Samsung Dishwasher Models

This guide applies to Samsung dishwashers with FBI (fully built-in) or SBI (semi built-in) configurations. Check your user manual for specific model compatibility. Common affected models include:

• Samsung DW50Rxxxxx series
• Samsung DW80Rxxxxx series
• Samsung DW60Rxxxxx series

3. How to Adjust the Tension Screws on Your Samsung Dishwasher

1. Open the dishwasher door to approximately 30 degrees to access the tension screws located on the front left and front right sides of the unit.
2. Identify the two tension screws responsible for spring adjustment. These screws control the door's resistance against gravity when opened.
3. Rotate both screws simultaneously in the same direction to increase or decrease tension. Turning clockwise increases tension; turning counterclockwise decreases it.
4. Test the door position after each adjustment. The door should remain stable when opened to 20–30 degrees and fully open positions.
5. Ensure both screws are set to the same position to maintain balanced tension across the door.

4. Additional Things to Check

- Verify that your custom panel does not exceed 10 kg in weight. Panels heavier than this may cause the door to fall open despite proper screw adjustments.

- Confirm the panel dimensions match those specified in your dishwasher's user manual. Incorrect sizing can interfere with door stability.

- Avoid adjusting the tension screws when the door is fully open. Always make adjustments with the door partially open (20–30 degrees).

5. When Updates May Not Appear

If the door still does not stay in place after adjusting the screws:

1. Double-check that the custom panel meets all specifications in your user manual.
2. Inspect the tension screws for damage or wear. Replace if necessary.
3. Contact Samsung Support for further assistance if the issue persists.

Related Samsung Support Topics

- How to install a custom panel on your Samsung dishwasher

- Understanding FBI and SBI dishwasher configurations

- Troubleshooting common Samsung dishwasher issues